Dynamic Feeds

Back to Press Feeding

Back to Products Page

DX/EV - High Speed Performance
Designed primarily for high speed applications, the computer-controlled DX/EV offers continuous
speed and accuracy up to 800 strokes-per-minute.

Material is fed through rolls made of hardened steel with permanently sealed and lubricated bearings. This reduces maintenance problems caused by dust and dirt contamination.

The resolver-based, AC brushless servo motor is mounted to the underside of the feed making it compact and easy to mount to the front, back or either side of a press.

	AC brushless servo drive motor
	Hardened precision ground steel feed rolls
	Upper and lower feed rolls driven through a toothed belt
	Upper roll pilot release precisely controlled by a high speed cylinder
	"End of stock" proximity switch
	Fully computerized controller with: · User-friendly keypad. · Forward/reverse jog control. · Emergency stop button. · Main power switch. · RS 232 link for remote programming. · Discrete outputs for user-defined options

	Under-driven AC motor makes it compact and easy to mount
	The user-friendly controller can be easily programmed
	Strip location can be determined by two independently adjustable guide rolls on feed entrance
	Permanently sealed, lubricated bearings reduce maintenance problems caused by dust and dirt contamination
	Easily mounts to front, back or either side of a press
	Pre-programmed acceleration and deceleration curves eliminate operator input
	Dynamic Feeds' proprietary software can be easily modified for special applications

Standard Pilot Release
The Model DX/EV comes standard with pneumatic, high speed pilot release system precisely controlled by a patented central cylinder. Pressure is controlled by a single regulator for both clamping and pilot release.

Pre-Programmed For Quick Set Up
Completely computer-controlled, the DX/EV is pre-programmed to walk the operator through a simple two step start-up process:

1. feed length
2. speed rate

The feed then automatically sets itself up for production. Acceleration
and deceleration curves are pre-programmed for optimum speed and operator ease.

Strokes Per Minute vs. Feed Length

Model Number	Material Width	Material Thickness	Material Cross Section	Feed Length	Feed Accuracy
DX/EV 12	.197"-4.72"	.002"-.098"	.310 sq. "	.004"-256"	.002"
DX/EV 22	.197"-8.66"	.002"-.098"	.310 sq. "	.004"-256"	.002"
DX/EV 112	.197"-4.72"	.004"-.157"	.620 sq. "	.004"-256"	.002"
DX/EV 122	.197"-8.66"	.004"-.157"	.620 sq. "	.004"-256"	.002"
DX/EV 220	.197"-8.66"	.004"-.24"	1.395 sq. "	.004"-256"	.002"
DX/EV 320	.197"-12.6"	.004"-.24"	1.395 sq. "	.004"-256"	.002"
DX/EV 420	.197"-16.5"	.004"-.24"	1.395 sq. "	.004"-256"	.002"
DX/EV 520	.197"-20.5"	.004"-.24"	1.395 sq. "	.004"-256"	.002"

** Other models and options are available for special applications.